•How to upgrade your JetBlack VOLT to make compatible with Zwift Cog & Click?
ONLY VOLT 2.0 can be compatible with Zwift Cog & Click. This can be achieved with a firmware update. The VOLT 1.0 is old technology and unfortunately unable to support the firmware update needed to be compatible with Zwift Cog & Click.
WARNING: The firmware upgrade is NOT COMPATIBLE with VOLT 1.0 or JetBlack Whisper Drive. If installed on non compatible units, it could overload the unit and cause sensor or other damage.
DO NOT INSTALL VOLT2.0 Cog and Click firmware upgrade on any other trainer except VOLT 2.0
HOW TO INSTALL THE FIRMWARE UPGRADE
1. Confirm you have VOLT 2.0.
You will notice a different shape to the drive side of the trainer. VOLT 1.0 has a flat cap, VOLT 2.0 has a sloped cap.
You will need to request a user code from our customer support team. Please contact support@jetblackcycling.com and you will be provided a code to use with the JB smart trainer app.
Once you have your code - follow these steps:
2. OPEN JETBLACK SMART TRAINER APP
• Go to Settings
• Advanced settings
• Enable Firmware preview
• Go Back to Settings
• Tap on FIRMWARE UPDATE
• Tap on 3 Dots (top right)
• Enter Code: Provided by customer service
• Update
• Wait for LED to start flashing Blue
• Exit JetBlack app and go to Zwift ensuring LED is flashing Blue.
3. CHECK IT'S WORKING WITH ZWIFT COG & CLICK
- Open Zwift App
- Connect controllable trainer.
- Tap on your Click device to activate.
- Tap on Controllers.
- NOTE: click cannot be Bridged via the trainer, Click can only be used via Bluetooth connection. It can be connected via the Zwift companion app also.